Expert Sign Installation

Your sign will be shipped ready to install. Anyone with basic carpentry skills should be able to install the sign. 3D Interior Signs also offers local professional sign installation services. Contact us for details!

For sign installation

You will need the following:

Step by Step

Sign installation instructions

Photo 1

Photo 2

Photo 3

1. Open box and check contents.

2. Unroll pattern and check sign installation layout.

3. Find center of pattern (right to left) with tape measure & mark with pencil.

4. Mount studs on backs of all letters and logos (Photo 1)

5. Place each letter/logo over the corresponding outline on the
pattern and line up studs with marked holes. If there are any
identical letters/logos they will be numbered. Make sure they go over
their corresponding outline because the stud placement is different
for each letter/logo.

6. Stand over sign patterns and check for any misalignment.

7. If any letters/logos are off, it will only be very slightly.
Carefully adjust if needed and mark new holes.

8. Stand over sign pattern and check again.

9. Confirm mounting area on wall and determine center placement of sign.

10. Mount pattern at preferred height and center right to left

11. Straighten pattern using level and tape down corners. (Photo 2.)

12. Stand back and check. Adjust as needed.

13. Tape down pattern smooth and check again with level.

14. Stand back and check one more time before drilling.

15. Drill over marked holes (drill bit should be only slightly larger
than studs) (Photo 3.)

16. Carefully removesign pattern from wall.

17. Temporarily mount letters in holes and stand back and check.

18. Slightly adjust any letters/logos if needed and use studs in
letters to hog out holes if needed. If wall is brick or other dense
surface you will need to use drill.

19. Remove letters/logos.

20. Blow out dust from holes (use drinking straw if available)

21. Fill holes with small amount of silicone. If sign is being
installed outside use a little more.

22. Mount sign letters/logos into holes.

23. Stand back and check.

24. Adjust letters as need and tape down if needed while silicone cures.

25. Clean off smudges with soft cotton cloth and water.
Use a very small drop of hand soap in water